Tuesday, January 2, 2018
Setting up of MTNLs B450TC1 modem cum WiFi router
Setting up of MTNLs B450TC1 modem cum WiFi router
Recently I had the opportunity to setup a B 450TC1 wireless modem cum router. Setting up is fairly straight forward & should not be a problem for anyone. To set up
https://www.grc.com/passwords.htm
https://secure.pctools.com/guides/password/
1) We first open a browser & type 192.168.1.1 in the location bar.
You will see a similar pop up on your screen. The User Name is �admin� and Password is also �admin� after
2) Next you will see the following window
3) Click on the tab �Interface Setup� -> �Internet�
4) Make �Virtual Circuit� as �PVC 0�
5) Make �Status� as �Activated�
6) Make �VPI� as �0� and �VCI� as �32�
7) Select �ISP� as �PPPoA/PPPoE�
8) Type your Telephone as your �Username�
9) And your CA No. as your �Password� (CA number is your Customer A/c number found on your tel bill)
10) Next type TCP MSS = 1360 Bytes or leave it as 1400 (Default).
11) And type TCP MTU = 1492 Bytes.
12) Go to the bottom of the page & click on �Save�.
13) To enable DHCP go to Interface Setup->;LAN and select DHCP option
These VCI & VPI I have mentioned above is basically for MTNL for the other ISP�s in India it�s the following
Connection Name | VPI | VCI |
MTNL | 0 | 32 |
BSNL | 0 | 35 |
Airtel | 1 | 32 |
VSNL | 0 | 33 |
14) If you notice �DNS Relay� is set as �User Discovered� ie hard coded, I would suggest that it�s set to Auto Discovery.
15) To save click on Save button at bottom of page.
16) Go to the �Maintenance� tab & then on �Sysrestart� (See Below)
17) Select �Current Settings�
18) Click on �Restart�
The basic ADSL modem setting are finished. To check if you are connected to the internet in the setting of the modem/router go to the �Status� tab as seen below.
To setup the WiFi.
Open the router page as mentioned as before
Go to �Interface Setup� ->�Wireless� (See Below)
Make �Access Point� as �Activated�
Add a SSID (Your Network name) of your choice but not your name of address.
Authentication Type is selected as WPA2-PSK
Encryption is selected as TKIP/AES
Pre shared key is the wifi password. For generating long random passwords you can use
https://www.grc.com/passwords.htm
https://secure.pctools.com/guides/password/
For further security I would suggest using the MAC filters for which in the above picture
Select �Active�
Action should be made �Allow Association�. And the MAC addresses of the gadgets you want to connect to the WiFi router should be added
Lastly click on �Save� then as above
Go to the �Maintenance� tab & then on �Sysrestart�
Select �Current Settings�
Click on �Restart�
I am now presuming you know how to get your other gadgets connected to this wifi router.
I am given to understand that this screenshots & setup is similar for UT-Star wireless Type II & IV, Beetel Type A 410TC1m, wireless type B 450TC1 & type C 480TC1.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.